When turning from “ACC” to “LOCK”When turning from “ACC” to “LOCK”  - Ignition switch - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

[Vehicles equipped with M/T] Put the gearshift lever into the “N” (Neutral) position, and slowly turn the ignition switch to the “LOCK” position while pressing it.

[Vehicles equipped with CVT or Twin Clutch SST] First, set the selector lever (CVT) or the gearshift lever (Twin Clutch SST) to the “P” (PARK) position, and then slowly turn the ignition switch to the “LOCK” position while pressing it.

Note

► Vehicles equipped with CVT or Twin Clutch SST, the ignition switch cannot be Note

► Vehicles equipped with CVT or Twin Clutch SST, the ignition switch cannot be turned to the “LOCK” position unless the selector lever (CVT) or the gearshift lever (Twin Clutch SST) is in the “P” (PARK) position.

► Do not turn the ignition switch to the “LOCK” position while driving. The Caution

► Do not turn the ignition switch to the “LOCK” position while driving. The steering wheel will be locked, causing loss of control.
► If the engine is stopped while driving, the brake servomechanism will cease to function and braking efficiency will deteriorate.
Also, the power steering system will not function and it will require greater manual effort to operate the steering.
► Do not leave the ignition switch in the “ON” or “ACC” position for a long time when the engine is not running, doing so will cause the battery to be discharged.
► Do not turn the ignition switch to the “START” position when the engine is running, doing so could damage the starter motor.

    See also:

    Weights (Hatchback)
    Sedan Hatchback ...

    Battery
    The condition of the battery is very important for quick starting of the engine and proper functioning of the vehicle’s electrical system. Regular inspection and care are especially important in ...

    Headlamp washer switch*
    The headlamp washer can be operated with the ignition switch “ON” position and the lamp switch at “” or “” position. 1- Push the button once and the washer fluid will be sprayed on ...