Keyless operation key take-out monitoring systemKeyless operation key take-out monitoring system - Warning activation - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Type 1

Type 2

Type 2

When the vehicle is parked with the ignition switch in any position other than

When the vehicle is parked with the ignition switch in any position other than “LOCK” (PUSH OFF), if you close the door after opening any of the doors and taking the keyless operation key out of the vehicle, a warning displays and the buzzer sounds 4 times.

► If you take the keyless operation key out of the vehicle through a window without Note

► If you take the keyless operation key out of the vehicle through a window without opening a door, the keyless operation key takeout monitoring system does not operate.

► It is possible to change the setting to make the keyless operation key take-out monitoring system operate if you take the keyless operation key out from the vehicle through a window without opening a door. For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.

► Even if you have the keyless operation key within the engine start operating range, if the keyless operation key and vehicle ID codes cannot be matched, for example due to the ambient environment or electromagnetic conditions, the warning may be activated.

    See also:

    Fuel remaining display screen
    This displays the amount of fuel remaining. CAUTION • For petrol-powered vehicles, do not run out of fuel, or the catalytic converter may be adversely affected. If the warning display appear ...

    Emergency stop signal system
    This is a device that reduces the possibility of rear end collisions by the rapid and automatic blinking of the hazard warning lamps to alert vehicles approaching from behind during sudden braking ...

    To resume the set speed
    If the set speed driving is deactivated by the condition described in “To deactivate”, you can resume the previously set speed by pressing the “ACC RES” switch (C) while driving at a speed o ...