To lockTo lock  - Keyless entry system - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal lamps will blink once.

► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two Note

► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two times in succession causes the Dead Lock System to be set. (Refer to “Setting the system”.)

    See also:

    Interior lamps
    1- Luggage room lamp 2- Room lamp (rear)* 3- Map & room lamps (front) Sunshade illumination dimming control switch* NOTE • If you leave the lamps on without running the engine, you will r ...

    High–mounted stop lamp
    Hatchback Place the groove of clip top as shown, then remove the cover. Undo bolts (A), remove the lamp body, and disconnect the connector. Undo screws (B) and take the bulb out of its socket ...

    Driver’s knee airbag system
    The driver’s knee airbag is located under the steering wheel. The driver’s knee airbag is designed to deploy at the same time as the driver’s front airbag. ...