Setting of door and rear hatch unlock function (vehicles equipped with the central door lock switch)
The door and rear hatch unlock function can be set to the following two conditions.
Each time the door and rear hatch unlock function is set, a chime will sound to tell you the condition of the door unlock function.
1. Turn the ignition switch to the “LOCK” position. If you started the engine
with the key, remove the key from the ignition switch.
2. Place the combination headlamps switch and dipper switch in the “OFF” position,
and leave the driver’s door open.
3. Press the LOCK switch (1) for 4 to 10 seconds and press the UNLOCK switch (2)
during this time.
4. Release in sequence the LOCK and UNLOCK switches within 10 seconds of pressing
the LOCK switch in step 3.
Note
► On vehicles equipped with Mitsubishi Multi- Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
Front fog lamps
Remove the cover mounting screw.
Remove bolts (1) and (2) with a screwdriver, and pull the lamp body towards you.
NOTE
Do not turn the aiming adjusting bolt (3).
Remove the connector secured ...
Information screen (when the ignition switch is turned from “OFF” to “ON”)
When the ignition switch is turned to the “ON” position, the display screen switches
in the following order.
1- Screen when the ignition switch is “OFF”
2- System check screen
3- Screen ...
Radio data system (RDS)
1- PWR (On-Off) switch
2- AM/FM (FM/MW/LW selection) button
3- Memory select buttons
4- TP (Traffic program) button
5- PTY (Program type) button
6- TUNE switch
7- SEEK (Up-seek) button
8- S ...