Type 1 (Vehicles equipped with the central door lock switch)
Note
► Each of the doors can be locked or unlocked independently by using the inside lock knob.
► When locking or unlocking with the key on the driver’s door, only the driver’s door will lock or unlock.
► Repeated continuous operation between lock and unlock could activate the central door locking systems built-in protection circuit and prevent the system from operating. If this occurs, wait approximately 1 minute before operating the central door lock switch.
► When the driver’s door is open, neither the key nor the central door lock switch can be used to lock it.
Using the central door lock switch
1- Lock
2- Unlock
All doors can be locked or unlocked by pressing the central door lock switch on the driver’s door.
See also:
Radio data system (RDS)
1- PWR (On-Off) switch
2- AM/FM (FM/MW/LW selection) button
3- Memory select buttons
4- TP (Traffic program) button
5- PTY (Program type) button
6- TUNE switch
7- SEEK (Up-seek) button
8- S ...
Front passenger seat belt warning lamp
The front passenger seat belt warning lamp is located on the instrument panel.
The lamp comes on when a person sits on the front passenger seat but does not
fasten the seat belt. It goes off when ...
3-point type seat belt with 2 buckles
3-point type seat belt with 2 buckles is fitted in the rear centre seating position.
To fasten
1. Pull the seat belt out slowly and pass it through the seat belt guide (A).
NOTE
• When the se ...