Testing the system
Open all of the door windows, then set the Dead Lock System. (Refer to “Setting the system”.) After setting the Dead Lock System, reach into the vehicle through a window and confirm that you cannot unlock the doors using the lock knobs.
Note
► If you need advice on how to set the Dead Lock System, please contact a MITSUBISHI MOTORS Authorized Service Point.
See also:
Operating the air conditioning system
Heating
Set the mode selection dial to the
position and set the air selection switch (A) to the outside position.
Turn the temperature control dial clockwise or anticlockwise to the desired temper ...
Side turn-signal lamps
Insert a straight blade (or minus) screwdriver at the edge of the lens, remove
the socket assembly and bulb together by turning it anticlockwise, and then remove
the bulb by pulling out.
NOTE
...
Twin Clutch SST control mode
Select the control mode from the following two types to suit the driving conditions.
Note
► When continuously driving on closed circuit tracks or at other locations where
the engine is op ...