Changing the security alarm settingsChanging the security alarm settings  - Security alarm system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

It is possible to set the security alarm to the “active” mode or “inactive” mode.

Follow the procedure below.

1. Turn the ignition switch to the “LOCK” position.

If you started the engine with the key, remove the key from the ignition switch.
2. Place the lamp switch in the “OFF” position, and leave the driver’s door open.

3. Pull the windscreen wiper and washer switch towards you and hold it there.

3. Pull the windscreen wiper and washer switch towards you and hold it there. (Since the ignition switch is in the “LOCK” position, washer fluid will not be sprayed.)

4. After approximately 10 seconds, the buzzer will make a sound. Keep the windscreen

4. After approximately 10 seconds, the buzzer will make a sound. Keep the windscreen wiper and washer switch pulled towards you. (If the windscreen wiper and washer switch was released, the setting change mode would be cancelled. To start over, perform the procedure again from step 3.)
5. When the buzzer stops, with the windscreen wiper and washer switch still pulled towards you, press the UNLOCK switch (A) on the remote control switch to select the security alarm settings mode.

The settings mode can be toggled by pressing the UNLOCK switch. The mode can

The settings mode can be toggled by pressing the UNLOCK switch. The mode can be confirmed from the number of times the buzzer sounds.

6. Any of the following operations can be used to terminate the system settings

6. Any of the following operations can be used to terminate the system settings change mode.

• Releasing the windscreen wiper and washer switch.
• Closing the driver’s door.
• Inserting the key into the ignition switch.
• Placing the lamp switch in any position other than “OFF”.
• Allowing 30 seconds to pass without making any changes to the settings.
• Push the ignition switch to the “LOCK” (PUSH ON) position (Vehicles with keyless operation system).

► If anything with regard to making changes to the security alarm system settings Note

► If anything with regard to making changes to the security alarm system settings is hard to understand, please consult your MITSUBISHI MOTORS Authorized Service Point.
► Avoid leaving valuable items inside the vehicle even when the security alarm system has been set to the “active” mode.

    See also:

    Keyless operation system
    The keyless operation system allows you to lock and unlock the doors and tailgate and start the engine simply by carrying the keyless operation key with you. The keyless operation key can also be u ...

    Driver’s seat belt warning lamp and display
    Warning lamp A tone and warning lamp are used to remind the driver to fasten the seat belt. If the ignition switch is turned to the “ON” position or the operation mode is put in ON while a ...

    Used engine oils safety instructions
    WARNING (1) Prolonged and repeated contact may cause serious skin disorders, including dermatitis and cancer. (2) Avoid contact with the skin as far as possible and wash thoroughly after any cont ...