Cancelling the alarmCancelling the alarm - Security alarm system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

It is possible to halt the activation of an alarm using the following methods: ► Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and rear hatch are closed, after which the system preparation mode will once again go into effect.)
► Turning the ignition switch to the “ON” position.

► Holding the keyless operation key and locking and unlocking the doors and the rear hatch using the keyless operation function (vehicles equipped with the keyless operation system).

► When the ignition switch is turned to the “ON” position, the buzzer sounds Note

► When the ignition switch is turned to the “ON” position, the buzzer sounds 4 times.
This operation indicates that the alarm was activated while the vehicle was parked.
Please check the inside of the vehicle to confirm that nothing was stolen.
► Even if the battery is disconnected, the alarm activation memory will not be erased.

    See also:

    Fluid type
    Use brake fluid conforming to DOT3 or DOT4 from a sealed container. The brake fluid is hygroscopic. Too much moisture in the brake fluid will adversely affect the brake system and clutch system, ...

    Ashtray
    CAUTION • Put out matches and cigarettes before they are placed in the ashtray. • Don’t put papers and other things that burn into your ashtrays. If you do, cigarettes or other smoking mate ...

    Turbocharger operation
    Caution ► Do not run the engine at high speeds (for example, by revving it or by accelerating rapidly) immediately after starting it. ► Do not stop the engine immediately after high-s ...