To fastenTo fasten - 3-point type seat belt (with emergency locking mechanism) - Seat belts - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

1. Pull the seat belt out slowly while holding the latch plate.

► When the seat belts cannot be pulled out in a locked condition, pull the belts Note

► When the seat belts cannot be pulled out in a locked condition, pull the belts once forcefully and then return them. After that, pull the belts out slowly once again.

2. Insert the latch plate into the buckle until a “click” is heard.

Warning

► Never wear the lap portion of the belt across your abdomen. During accidents Warning

► Never wear the lap portion of the belt across your abdomen. During accidents it can press sharply against the abdomen and increase the risk of injury.
► The seat belts must not be twisted when worn.

3. Pull the belt slightly to adjust slackness as desired.

    See also:

    The security alarm has four modes
    System preparation mode (approx. 20 seconds) (The buzzer sounds intermittently and the security indicator (A) blinks.) The system preparation time extends from the point at which all of the doors ...

    Hydraulic power steering system (HPS)
    The hydraulic power steering system (HPS) uses a hydraulic pressure pump to assist the turning of the steering wheel. Caution ► Do not leave the steering wheel turned all the way in one dir ...

    Child-protection rear doors
    1- Lock 2- Unlock Child protection helps prevent the rear doors from being opened accidentally from the inside. If the lever is set to the locked position, the rear door cannot be opened using ...