Installing a child restraint system to a 3-point type seat belt (with emergency locking mechanism)Installing a child restraint system to a 3-point type seat belt (with emergency 
locking mechanism)  - Child restraint - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Installation:

Installation:

1. Fasten the seat belt to secure the child restraint system. Make sure you hear a “click” when you insert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all directions to be sure it is secure.

► For some types of child restraint, the locking clip (A) should be used to Warning

► For some types of child restraint, the locking clip (A) should be used to help avoid personal injury during a collision or sudden manoeuvre.
It must be fitted and used in accordance with the child restraint manufacturer’s instructions.
The locking clip must be removed when the child restraint is removed.

Seat belt inspection

    See also:

    Disconnection and connection
    To disconnect the battery cable, stop the engine, first disconnect the negative (-) terminal and then the positive (+) terminal. When connecting the battery, first connect the positive (+) terminal ...

    Loading luggage
    When loading luggage, be careful not to load above the height of seats. This is dangerous not only because rearward vision will be obstructed, but also the luggage may be projected into the passen ...

    Tyre chains
    If tyre chains have to be used, ensure that they are fitted only on the front wheels. Use only tyre chains which are designed for use with the tyres mounted on the vehicle: use of the incorrect si ...