Seat belt inspection
► Check the belts for cuts, worn or frayed webbing and for cracked or deformed
metallic parts. Replace the belt assembly if it is defective.
► A dirty belt should be cleaned with neutral detergent in warm water. After rinsing
in water, let it dry in the shade. Do not attempt to bleach or re-dye the belts
because this will affect their characteristics.
Warning
► We recommend you to have all seat belt assemblies including retractors and
attaching hardware inspected after any collision.
We recommend that seat belt assemblies in use during a collision be replaced unless
the collision was minor and the belts show no damage and continue to operate properly.
► Do not attempt to repair or replace any part of the seat belt assemblies; we recommend
you to have this work done by a MITSUBISHI MOTORS Authorized Service Point. Incorrect
repair or replacement could reduce the effectiveness of the belts and could result
in serious injury in the event of a collision.
► Once the pretensioner has been activated, it cannot be re-used.
It must be replaced together with the retractor.
See also:
Child restraint system with ISOFIX mountings
The child restraint system is designed only for seats that incorporate lower
anchorages. Retain the child restraint system using the lower anchorages.
It is not necessary to retain the child restra ...
Indication and warning lamp list
1- Position lamp indication lamp ®
2- High-beam indication lamp ®
3- Charge warning lamp ®
4- Turn-signal indication lamps/Hazard warning indication lamps ®
5- Front fog lamp indication lamp ...
Side airbag system
The side airbags (A) are contained in the driver and front passenger seatbacks.
The side airbag is designed to inflate only on the side of the vehicle that is
impacted, even with no passenger in th ...