Information screen (when the ignition switch is turned from “OFF” to “ON”)
When the ignition switch is turned to the “ON” position, the display screen switches in the following order.
1- Screen when the ignition switch is “OFF”
2- System check screen
3- Screen when the ignition switch is “ON”
System check screen
When the ignition switch is turned to the “ON” position, the system check screen is displayed for about 4 seconds. If there is no fault, information screen (when the ignition switch is “ON” ) is displayed.
If there is a fault, the screen changes to warning display.
Refer to “Warning display list (when the ignition switch is “ON”)”.
Note
► The system check screen display varies depending on the customer’s equipment.
Service reminder
When the time for periodic inspection arrives, the warning display is displayed for a few seconds after the ignition switch “ON”. Refer to “Service reminder”.
See also:
Brake warning display
This warning is displayed if you drive with the parking brake still applied.
The warning lamp in the instrument cluster only illuminates when the parking brake
is applied.
Caution
► If ...
SRS servicing
WARNING
• We recommend any maintenance performed on or near the components of the
SRS to be performed by a MITSUBISHI MOTORS Authorized Service Point.
Improper work on the SRS components or wir ...
Operation of the Dead Lock System
With a vehicle that has a Dead Lock System, it is possible to set the Dead Lock
System using the driver’s or front passenger’s door lock/unlock switch, or the rear
hatch LOCK switch. (Refer to ...