Active Stability Control (ASC) OFF display screenActive Stability Control (ASC) OFF display screen  - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

This is displayed when the Active Stability Control (ASC) is turned off with

This is displayed when the Active Stability Control (ASC) is turned off with the ASC OFF switch.

If there is a fault with the ASC, the ASC OFF display is shown.

Refer to ““ASC OFF” switch”.

    See also:

    Setting the system
    1. Turn the ignition switch to the “LOCK” position. Also, if a key was used to start the engine, remove the key from the ignition switch. 2. Get out of the vehicle. Close all doors and rear ha ...

    To lock
    Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal lamps will blink once. Note ► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1 ...

    To tune the radio
    Automatic tuning After pressing the SEEK button (5 or 6), a receivable station will be automatically selected and reception of the station will begin. Manual tuning The frequency changes every ti ...