Manual reset modeManual reset mode  - Average speed display - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.

► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode setting is automatically switched from manual to auto.

Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.

    See also:

    Cup holder
    CAUTION • Do not drink beverages while driving. This is distracting and could cause an accident. For the front seat The cup holders are located in front of the floor console box. For the rea ...

    Display unit selection
    Originally, km/h and L/100 km are selected. When you want to select the unit “mile”, follow this procedure. NOTE For vehicles without MITSUBISHI genuine audio system, only the unit of averag ...

    AWC control fluid
    To check the fluid level The AWC control fluid reservoir is in the luggage compartment. Note ► Check the fluid level in the reservoir 90 minutes or more after turning the ignition switch t ...