Auto reset modeAuto reset mode  - Average speed display - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.

► If the ignition switch is at “ACC” or “LOCK” for about 4 hours or longer, the average speed display is automatically reset.

► The average speed display and the average fuel consumption display can be reset Note

► The average speed display and the average fuel consumption display can be reset individually for the auto reset mode and manual reset mode.
► “---” is displayed when the average speed cannot be measured.
► The initial (default) setting is “Auto reset mode”.
► The display setting can be changed to the preferred units (km/h or mph).
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
► The memory of the auto reset mode or manual reset mode for the average speed display is erased if the battery is disconnected.

    See also:

    Headlamp washer switch*
    The headlamp washer can be operated with the ignition switch “ON” position and the lamp switch at “” or “” position. 1- Push the button once and the washer fluid will be sprayed on ...

    Assist grips
    The assist grips (located above the doors on the headliner) are not designed to support body weight. They are intended for use only while seated in the vehicle. CAUTION • Do not use the assi ...

    Front passenger’s airbag ON-OFF switch
    The front passenger’s airbag ON-OFF switch can be used to disable the front passenger’s airbag. If you have a child restraint system that cannot be fitted to any seat other than the front pass ...