Instruments and controlsInstruments and controls  - Average fuel consumption display - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode setting is automatically switched from manual to auto.

Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.

    See also:

    Service reminder
    Displays the approximate time until the next periodic inspection that MITSUBISHI MOTORS recommends. “---” is displayed when the inspection time has arrived. Note ► Depending on the veh ...

    Key lock-in prevention system
    When the ignition switch is in the “LOCK” (PUSH OFF) position, if you close all the doors and the rear hatch with the keyless operation key left in the vehicle and you try to lock the doors ...

    Driver’s switches
    The driver’s switches can be used to operate all door windows. A window can be opened or closed by operating the corresponding switch. Press the switch down to open the window, and pull up the sw ...