Auto reset mode
► When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset.
► If the ignition switch is at “ACC” or “LOCK” for about 4 hours or longer, the average fuel consumption display is automatically reset.
Note
► The average speed display and the average fuel consumption display can be reset
individually for the auto reset mode and manual reset mode.
► “---” is displayed when the average fuel consumption cannot be measured.
► The initial (default) setting is “Auto reset mode”.
► The average fuel consumption depends on the driving condition (road condition,
driving behavior, etc.). The displayed fuel consumption may vary from the actual
fuel consumption.
Treat the fuel consumption displayed as just a rough guideline.
► The memory of the auto reset mode or manual reset mode for the average fuel consumption
display is erased if the battery is disconnected.
► The display setting can be changed to the preferred units {km/L, mpg (US), mpg
(UK) or L/100 km}.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
See also:
Caution for installing the child restraint on vehicles with a front
passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
WARNING
• Extreme Hazard! Do not use a rearward facing child restraint on a seat protected
by an airbag in front of ...
Front passenger seat belt warning lamp
The front passenger seat belt warning lamp is located on the instrument panel.
The lamp comes on when a person sits on the front passenger seat but does not
fasten the seat belt. It goes off when ...
Front passenger’s airbag OFF indication lamp
The front passenger’s airbag OFF indication lamp is located in the instrument
panel.
The indicator normally illuminates when the ignition switch is turned to the
“ON” position or the oper ...