Interrupt display screen (when the ignition switch is “ON”)
Warning display
When there is information to be announced, such as a system fault, a sound is emitted and the information screen switches to the warning display screen.
Refer to the warning list and take the necessary measures.
Refer to “Warning display list (when the ignition switch is “ON”)”.
When the cause of the warning display is eliminated, the warning display goes out automatically.
To return to the screen displayed before the warning display
Even if the cause of the warning display is not eliminated, you can return to the screen that was displayed before the warning display.
If you press the multi-information meter switch, the display screen switches to the screen that was displayed before the warning display and the mark (A) is displayed.
Note
► Warning display screens with a or mark displayed in the upper right of the screen can be switched. If you want to switch the display, press the multi-information meter switch as follows.
: Press lightly.
: Press for about 2 seconds or more.
Redisplay of a warning display screen
When the mark is displayed, if you lightly press the multi-information meter switch a few times, the warning display screen you switched from is displayed again.
Other interrupt displays
The operation status of each system is displayed on the information screen.
Refer to the appropriate page in the warning display list for further details.
Refer to “Other interrupt displays (when the ignition switch is “ON”)”.
See also:
Driving hints
(1) TCL does not actively apply brakes. Always decelerate the vehicle sufficiently
before entering corners or bends. (2) On snowy or icy roads, drive slowly using
tyre chains or snow tyres. (3) Wh ...
Cautions on handling of 4-wheeldrive vehicles
Tyres and wheels
Since the driving torque can be applied to the 4 wheels, the driving performance
of the vehicle when operating in 4-wheel drive is greatly affected by the condition
of the tyres. ...
Coming home light
This function turns on the headlamps in the low beam setting for about 30 seconds
after the ignition switch is turned to the “OFF” position or the operation mode
is put in OFF.
1. Turn the co ...