Changing the fuel consumption display unitChanging the fuel consumption display unit - Changing the function settings (when the ignition switch is “ON”) - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The display unit for fuel consumption can be switched.

The distance, speed, and amount units are also switched to match the selected fuel consumption unit.

1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.

Refer to “Changing the function settings (when the ignition switch is “ON”)”.

2. Lightly press the multi-information meter switch to select “AVG UNIT (fuel consumption display setting)”.

3. Press and hold the multi-information meter switch for about 2 seconds or more

3. Press and hold the multi-information meter switch for about 2 seconds or more to display “AVG UNIT” (fuel consumption display unit setting).

4. Lightly press the multi-information meter switch to switch in sequence from km/L → L/100 km → mpg (US) → mpg (UK) → RETURN → km/L.

5. Press and hold the multi-information meter switch for about 2 seconds or more

5. Press and hold the multi-information meter switch for about 2 seconds or more to change the setting to the selected unit.

► The display units for the driving range, the average fuel consumption, the Note

► The display units for the driving range, the average fuel consumption, the average speed and the momentary fuel consumption are switched, but the units for the indicating needle (speedometer), the odometer and the tripmeter will remain unchanged.
► The memory of the unit setting is erased if the battery is disconnected, and it returns automatically to L/100 km.

The distance and speed units are also switched in the following combinations to match the selected fuel consumption unit.

Changing the temperature unit

    See also:

    Door ajar prevention system
    When the ignition switch is in the “LOCK” (PUSH OFF) position, if you try to lock the doors and rear hatch by pressing the driver’s or front passenger’s door lock/unlock switch, or the r ...

    To operate without using the keyless operation function
    Emergency key The emergency key is built into the keyless operation key. If the keyless operation function cannot be used, for example because the keyless operation key battery has worn out or th ...

    Operation of the Dead Lock System
    In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the remote controller. (Refer to “Dead Lock System”.) ...