Changing the language cooperative controlChanging the language cooperative control  - Changing the function settings (when the ignition switch is “ON”) - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped) or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to the same language as that shown in the multi-information display.

1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select (language cooperative control).

3. Press and hold the multi-information meter switch to switch in sequence from

3. Press and hold the multi-information meter switch to switch in sequence from A or 1 (language cooperation enabled) → M, 2 or P (language cooperation disabled) → A or 1 (language cooperation enabled).

The setting is changed to the selected condition.

► The memory of the language cooperative control is erased if the battery is Note

► The memory of the language cooperative control is erased if the battery is disconnected, and it returns automatically to A or 1 (language cooperation enabled).
► The language display modified with the language setting can be switched in the following manner.
• When A or 1 (language cooperation enabled) has been selected with the language cooperative control, the language for MITSUBISHI Multi-Communication System (MMCS) (if so equipped) or the Bluetooth® 2.0 interface (if so equipped) is automatically changed to the language selected for the multi-information display.
• When M, 2 or P (language cooperation disabled) has been selected with the language cooperative control, the language for MITSUBISHI Multi-Communication System (MMCS) (if so equipped) or the Bluetooth® 2.0 interface (if so equipped) is not automatically changed to the language selected for the multi-information display.

    See also:

    Auto reset mode
    ► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset. ► If the ignition switch is at “AC ...

    Seat belts
    To protect you and your passengers in the event of an accident, it is the most important that the seat belts are worn correctly when you drive. The front seat belts have pre–tensioners. These bel ...

    Lower anchorage location
    Your vehicle’s rear seat is fitted with lower anchorages for attaching a child restraint system with ISOFIX mountings. ...