Information screen display list
When there is information to be announced, such as lamp reminders, a sound is emitted and the screen switches to the displays shown below. Refer to the appropriate page and take the necessary measures.
When the cause of the warning display is eliminated, the warning display goes out automatically.
Note
► A warning may be displayed on the information screen and the buzzer may sound
in the following rare cases.
This is caused by the system picking up interference such as noise or strong electromagnetic
waves, and is not a functional problem.
• An extremely strong electromagnetic wave is received from a source such as an
illegal radio set, a spark from a wire, or a radar station.
• Abnormal voltage or a static electricity discharge is generated by the operation
of installed electrical equipment (including after-market parts).
If the warning display appears many times, we recommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
See also:
Average speed display
This displays the average speed from the last reset to the present time.
There are the following 2 mode settings.
For the method for changing the average speed display setting, refer to “Changing ...
Removal of head restraints
To remove the head restraints, lift the head restraint with the height adjusting
knob (A) pushed in.
To install the head restraints, first confirm that they are facing in the correct
direction, ...
Auto Stop & Go (AS&G) system
The Auto Stop & Go (AS&G) system automatically stops and restarts the engine
without operating the ignition switch when the vehicle is stopped, such as at a
traffic light or in a traffic j ...