Turn-signal indication lamps/ Hazard warning indication lampsTurn-signal indication lamps/ Hazard warning indication lamps - Indication lamps - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Indication lamps / Turn-signal indication lamps/ Hazard warning indication lamps

These indication lamps blink in the following situations.

These indication lamps blink in the following situations.

► When the turn-signal lever is moved to activate a turn-signal lamp.

Refer to “Turn-signal lever”.

► When the hazard warning flasher switch is pressed to activate the hazard warning lamps.
Refer to “Hazard warning flasher switch”.
► When the hazard warning lamps automatically activate due to sudden braking while driving.

Refer to “Emergency stop signal system”.

► If these indication lamps blink too fast due to any operation other than sudden Note

► If these indication lamps blink too fast due to any operation other than sudden braking, the cause may be a blown lamp bulb or a faulty turn-signal connection.

    See also:

    Changing a fuse
    1. Before replacing a fuse, always turn off the electrical circuit concerned and turn the ignition key to the “LOCK” position. 2. Remove the fuse box cover. 3. Referring to the fuse load cap ...

    Changing the function settings (when the ignition switch is “ON”)
    1. Stop the vehicle in a safe place. Firmly apply the parking brake and put the gearshift lever into the “N” (Neutral) position (M/T), the selector lever into the “P” (PARK) position (CVT) ...

    Check engine warning lamp
    This lamp is a part of an onboard diagnostic system which monitors the emissions, engine control system or CVT control system/Twin Clutch SST control system. If a problem is detected in one of th ...