Fuel filter indicator displayFuel filter indicator display - Information screen display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

When the ignition switch is “ON”, if more than specified limit water has accumulated

When the ignition switch is “ON”, if more than specified limit water has accumulated in the fuel filter, a warning display is displayed on the information screen in the multi-information display.

► If this warning display is displayed we recommend you to have it checked. Caution

► If this warning display is displayed we recommend you to have it checked.
Prolonged driving with the warning display on the screen may damage the engine.

► If “REMOVE WATER IN SEPARATOR” does not go out or appears frequently after Note

► If “REMOVE WATER IN SEPARATOR” does not go out or appears frequently after removing the water, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

    See also:

    Selection of engine oil (diesel-powered vehicles)
    (1) Select engine oil of the proper SAE viscosity number according to the atmospheric temperature. (2) Use engine oil conforming to the following classification: Type 1:ACEA classification: “Fo ...

    How to enter PTYs in the memory
    As many as 6 PTYs can be entered in the memory. Follow the steps described below. 1. Press either the TUNE/SEEK button (5 or 6) to tune the PTY to be entered in the memory. 2. Press one of the mem ...

    Manual reset mode
    ► When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset. ...