Coming home lightComing home light  - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

This function turns on the headlamps in the low beam setting for about 30 seconds after the ignition switch is turned to the “LOCK” position.

1. Turn the combination headlamps and dipper switch to the “OFF” or “AUTO” position (for vehicles equipped with the automatic lamp control).
2. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key from the ignition switch.
3. Within 60 seconds of turning the ignition switch to the “LOCK” position, pull the turn signal lever towards you.

4. The headlamps will come on in the lowbeam setting for about 30 seconds. After

4. The headlamps will come on in the lowbeam setting for about 30 seconds. After the headlamps go off, the headlamps can be turned on again in the low beam setting for about 30 seconds by pulling the turn signal lever towards you within 60 seconds of turning the ignition switch to the “LOCK” position.

To turn on the headlamps again after 60 seconds of turning the ignition switch to the “LOCK” position, repeat the process from step 1.

► While the coming home light function is operating, perform one of the following Note

► While the coming home light function is operating, perform one of the following operations to cancel the function.
• Pull the lever towards you.
• Turn the combination headlamps and dipper switch to the • Turn the ignition switch to the “ON” position. position.
• Turn the ignition switch to the “ON” position.

► It is possible to modify functions as follows:
• The time that the headlamps remain on can be changed.
• The coming home light function can be deactivated.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment. Refer to the separate owner’s manual for details.

    See also:

    To unlock the doors and rear hatch
    You can select the function to unlock the doors and rear hatch either using the ignition switch position or using the selector lever position (CVT) or the gearshift lever position (Twin Clutch SST ...

    After driving on icy roads
    After driving on snow or icy roads, remove any snow and ice which may have accumulated around the wheels. On vehicles that have an ABS, be careful not to damage the wheel speed sensors (A) or the ...

    Rear-view camera
    The rear-view camera is a system that shows the view behind the vehicle on a screen of the MITSUBISHI Multi Communication System (MMCS) or the inside rear-view mirror. Caution ► The rear- ...