Rear fog lamp switchRear fog lamp switch  - Fog lamp switch - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The rear fog lamp can be operated when the headlamps or front fog lamps (if so equipped) turn on.

An indication lamp in the instrument cluster comes on when the rear fog lamp is turned on.

[Vehicles without front fog lamps] Turn the knob once in the “ON” direction to turn on the rear fog lamp. To turn the rear fog lamp off, turn the knob once in the “OFF” direction. The knob will automatically return to its original position when you release it.

[Vehicles with front fog lamps]

Turn the knob once in the “ON” direction to turn on the front fog lamps. Turn the knob once more in the “ON” direction to turn on the rear fog lamp. To turn the rear fog lamp off, turn the knob once in the “OFF” direction. Turn the knob once more in the “OFF” direction to turn off the front fog lamps.

The knob will automatically return to its original position when you release it.

Note

► The rear fog lamp is automatically turned off when the headlamps or front fog Note

► The rear fog lamp is automatically turned off when the headlamps or front fog lamps (if so equipped) are turned off.
► To turn the rear fog lamp on again, turn the knob once in the “ON” direction after turning on the headlamps. (Vehicles without front fog lamps)
► To turn the rear fog lamp on again, turn the knob twice in the “ON” direction after turning on the headlamps. (Vehicles with front fog lamps)
► In case of vehicles with Daytime Running Lamp, the rear fog lamp can be operated even if the lamp switch is set to the “OFF” position.

    See also:

    Cruise control
    Cruise control is an automatic speed control system that lets you keep the same driving speed. It can be activated at 40 km/h (25 mph) or more. CAUTION: ● When you do not wish to drive at a ...

    Safety
    The two sets of Latch anchors in the Outlander Sport are simple to use. But the Outlander Sport has a problem that I'm seeing more often: The seat belt buckles are placed too close to the doors. T ...

    ACD control mode display
    Example: “TARMAC” mode is selected. The currently selected control mode is displayed on the multi-information display. In addition, when the control mode is changed, the selected mode appears ...