Rear window wiper and washer
The rear window wiper and washer switch can be operated with the ignition switch in the “ON” or “ACC” position.
INT- The wiper operates continuously for several seconds then operates intermittently at intervals of about every 8 seconds
OFF- Off
The washer fluid will be sprayed onto the rear window when the knob is turned fully in either direction.
The wipers operate automatically several times while the washer fluid is being sprayed.
Note
► The rear window wiper will automatically perform several continuous operations
if the gearshift lever or the selector lever is put in the “R” position while the
windscreen wipers or the rear window wiper is operating. (automatic operation mode)
After the automatic operation, the rear window wiper will stop operating if the
knob is in the “OFF” position. If the knob is in the “INT” position, the rear window
wiper will return to the intermittent operation.
It is possible to set the rear window wiper to perform the automatic operation only
if the gearshift lever or the selector lever is put in the “R” position while the
rear window wiper is operating with the knob in the “INT” position.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
► If the knob is in the “OFF” position, turn the knob to the “INT” position twice
quickly to operate the rear window wiper continuously.
(continuous operation mode)
Turn the knob to the “OFF” position to stop the rear window wiper continuous operation.
► The interval for intermittent operation can be adjusted.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
Fuel remaining display screen
This displays the amount of fuel remaining.
CAUTION
• For petrol-powered vehicles, do not run out of fuel, or the catalytic converter
may be adversely affected.
If the warning display appear ...
Towing with a rope
1. For vehicles with automatic transmission check the automatic transmission
fluid level. (Refer to “Automatic transmission fluid” on page 9–4.) If the fluid
level is low, transport the ve ...
Display unit selection
Originally, km/h and L/100 km are selected. When you want to select the unit
“mile”, follow this procedure.
NOTE
For vehicles without MITSUBISHI genuine audio system, only the unit of averag ...