To reduce the glareTo reduce the glare  - Inside rear-view mirror - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Type 1

The lever (A) at the bottom of the mirror can be used to adjust the mirror to reduce the glare from the headlamps of vehicles behind you during night driving.

1- Normal

1- Normal
2- Anti-glare

Type 2

When the headlamps of the vehicles behind you are very bright, the reflection factor of the rear-view mirror is automatically changed to reduce the glare.

When the ignition switch is turned to the “ON” position, the green indicator

When the ignition switch is turned to the “ON” position, the green indicator (1) illuminates and the reflection factor of the mirror is automatically changed.

► Do not hang any items on, or spray glass cleaner on the sensors (2) on the Note

► Do not hang any items on, or spray glass cleaner on the sensors (2) on the front and back side, as reduced sensitivity could result.
► If you want to stop automatic mode, press the switch (3) and the indicator will go off.
To return to automatic mode, press the switch again or turn the ignition switch to the “ON” position after turning to “LOCK” or “ACC” position.

    See also:

    Chassis and underbody protection
    Your vehicle’s underbody has been treated at the factory in order to protect it from rust and corrosion. Some areas have been injected with anti-corrosion agents and wax. The effectiveness of th ...

    Steering wheel lock
    To lock Press the engine switch to put the operation mode in OFF. Open one of the doors. To unlock The following methods can be used to unlock the steering wheel. • Put the operation mode in AC ...

    Outside temperature display screen
    This shows the temperature outside the vehicle. Note ► The display setting can be changed to the preferred units (°C or °F). Refer to “Changing the function settings (when the ignition ...