Stopping the engineStopping the engine  - Starting and stopping the engine - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

1. Bring the vehicle to a complete stop.

2. Fully engage the parking brake while depressing the brake pedal.

3. For vehicles equipped with M/T, turn the ignition switch to the “LOCK” position to stop the engine, and then move the gearshift lever to the 1st (on a uphill) or “R” (Reverse) (on a downhill) position.

On vehicles with CVT or Twin Clutch SST, move the selector lever (CVT) or gearshift lever (Twin Clutch SST) to the “P” (PARK) position, and turn the ignition switch to the “LOCK” position to stop the engine.

► For vehicles equipped with Twin Clutch SST, the engine will stop and the vehicle Note

► For vehicles equipped with Twin Clutch SST, the engine will stop and the vehicle power will turn off approximately 1 second after the ignition switch is turned to the “LOCK” position.

The reason for this is that, in the time from when the ignition switch is turned to the “LOCK” position until the engine stops, the gears inside the Twin Clutch SST disengage so that the engine will start smoothly the next time it is started.

Two clutches installed in the Twin Clutch SST alternately engage and disengage to achieve smooth shifting.

In addition, the gear on the side with the free clutch is always engaged, therefore, quick shifting is performed.

If the engine was stopped with the gear engaged like this, it would provide resistance the next time the engine is started. Therefore, the gear disengages in the approximately 1- second period until the engine stops.

► For vehicles equipped with Twin Clutch SST, do not operate the gearshift lever or the accelerator pedal for approximately 1 second until the engine stops.

► For vehicles equipped with Twin Clutch SST, if the temperature inside the engine compartment is high, the cooling fans (A) will continue to operate for some time even if the engine is stopped.

Therefore, the operation sound of the cooling fans may be heard even after the engine is stopped. This sound is normal and does not indicate a malfunction.

After operating for a period of time, the cooling fans will stop automatically.

: Front of the vehicle

: Front of the vehicle

    See also:

    Except for vehicles equipped with rain sensor
    The windscreen wiper and washer can be operated with the ignition switch in the “ON” or “ACC” position. If the blades are frozen to the windscreen, do not operate the wipers until the ice ...

    System preparation mode (approx. 20 seconds)
    (The buzzer sounds intermittently and the security indicator (A) blinks.) The system preparation time extends from the point at which all of the doors and rear hatch are locked by pressing the LO ...

    Auto–speed (cruise) control*
    Auto–speed control is an automatic speed control system to maintain a desired driving speed of about 40 km/h or more without operating the accelerator pedal. This feature is especially useful f ...