Auto Stop & Go (AS&G) systemAuto Stop & Go (AS&G) system  - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The Auto Stop & Go (AS&G) system automatically stops and restarts the engine without operating the ignition switch when the vehicle is stopped, such as at a traffic light or in a traffic jam, to reduce exhaust gases, increase fuel efficiency.

► If the vehicle will be stopped for a long time or if you will leave the Caution

► If the vehicle will be stopped for a long time or if you will leave the vehicle unattended, turn the ignition switch to the “LOCK” position to stop the engine.

See also:

Door ajar warning display screen (when the ignition switch or the operation mode is ON)
If any of the doors or the tailgate is not completely closed, this displays the open door or tailgate. If the vehicle speed exceeds approximately 8 km/h (5 mph) while a door is ajar, a buzzer s ...

Dipper (High/Low beam change)
When the lamp switch is in the position, the beam changes from high to low (or low to high) each time the lever is pulled fully (1). While the high beam is on, the high-beam indication lamp in th ...

Range of view of rear-view camera
The range of view of the rear-view camera is limited to the area shown in the illustrations. It cannot show both sides and the lower part of the rear bumper, etc. When reversing, be sure to visua ...