Gearshift lever position display
When the ignition switch is turned to the “ON” position, the position of the gearshift lever is indicated in the multi-information display.
In addition, when the vehicle is driven with the gearshift lever in the “D” (DRIVE) position, the forward gear number is shown.
If the gearshift lever position display blinks and the buzzer beeps
With the gearshift lever in the “R” (REVERSE) position, if the gearshift lever position display blinks and the buzzer beeps, the transmission gears have not properly engaged. To correct this situation, the following procedure must be performed.
1. Depress the brake pedal with your right foot and place the gearshift lever
in the “N” (NEUTRAL) position.
2. Again place the gearshift lever in the “R” (REVERSE) position and confirm that
the gearshift lever position display has stopped blinking and that the buzzer has
stopped beeping.
3. Repeat 1 and 2 above if the gearshift lever position display continues to blink
and the buzzer beeps.
Warning
► To avoid unintended vehicle movement when the gearshift lever position display blinks and the buzzer beeps, keep brake pedal applied with your right foot and do not depress the accelerator pedal.
When the gearshift lever position display is not showing
There may be a problem in the Twin Clutch SST.
If this occurs, the safety device operates and prevents the vehicle from moving. Perform the following procedure.
1. Park your vehicle in a safe place and stop the engine.
2. Restart the engine.
If the gearshift lever position display is shown and the vehicle can move after this procedure is performed, there is no malfunction.
If the gearshift lever position display is not shown and the vehicle cannot move, or if this problem occurs repeatedly, have the vehicle checked by a MITSUBISHI MOTORS Authorized Service Point as soon as possible.
See also:
Information screen (when the ignition switch is turned from the “LOCK”
position to
the “ON” position or the operation mode is changed from OFF to
ON)
When the ignition switch is turned to the “ON” position or the operation mode
is put in ON, the display screen switches in the following order.
1- Screen when the ignition switch or the opera ...
Seat belts
To protect you and your passengers in the event of an accident, it is most important
that the seat belts be worn correctly while driving.
The front seat belts have a pretensioner system.
These bel ...
Manual reset mode
► When the average speed is being displayed, if you hold down the multi-information
meter switch, the average speed displayed at that time is reset.
► When the ignition switch is switch ...