What to do if the following occur with the Twin Clutch SST
If there is a malfunction in the Twin Clutch SST or engine electronic control module, the following may occur.
► Twin Clutch SST does not shift.
► Vehicle cannot move.
► Twin Clutch SST acceleration is slow.
► Vehicle does not creep.
► “Shift shock” is large.
► Shifting occurs at higher engine speed.
► Response is slow.
If either of these occurs, perform the following procedure.
When warning display is showing
The temperature of the Twin Clutch SST fluid is high. Refer to “Warning display” and follow the appropriate measures.
When the check engine warning lamp comes on or blinking
There could be a malfunction in the engine electronic control module. Refer to “Check engine warning lamp” and follow the appropriate measures.
When the gearshift lever position display is not showing
A safety device in the Twin Clutch SST has been activated due to a possible malfunction in the Twin Clutch SST. Refer to “When the gearshift lever position display is not showing” and follow the appropriate measures
When warning display is showing or when no warning is showing in the multi-information display
A safety device in the Twin Clutch SST has been activated due to a possible malfunction in the Twin Clutch SST or in the engine electronic control module.
Perform the following procedure.
1. Park your vehicle in a safe place and stop the engine.
2. Restart the engine.
If the vehicle moves and accelerates normally after this procedure is performed, there is no malfunction.
However, if the vehicle does not move or accelerate normally, or if this problem occurs repeatedly, have the vehicle checked by a MITSUBISHI MOTORS Authorized Service Point as soon as possible.
Caution
► When the Twin Clutch SST fluid temperature is high, the engine idle speed when the vehicle is stopped may increase or the vehicle will have a weak tendency to creep.
After that, if the Twin Clutch SST fluid temperature rises even higher, the warning display will appear.
See also:
Rear lid lamp
Remove the cover with a screwdriver. Turn the bulb socket anti-clockwise to remove
it. And remove the bulb from the socket by turning it anti-clockwise while pressing
it inward.
1- Reversing la ...
Retracting and extending the mirrors using the mirror retractor switch
With the ignition switch in the “ON” or “ACC” position, push the mirror retractor
switch to retract the mirrors. Push it again to extend the mirrors to their original
positions.
After pla ...
Air selection switch
To change the air selection, simply press the air selection switch.
A sound will be made every time you push the switch.
► Outside air: Indication lamp (A) is OFF Outside air is introduced int ...