ABS warning lamp/displayABS warning lamp/display - Anti-lock brake system (ABS) - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Warning lamp

If there is a malfunction in the system, the ABS warning lamp will come on and

If there is a malfunction in the system, the ABS warning lamp will come on and the warning display will appear on the information screen in the multi-information display.

Under normal conditions, the ABS warning lamp only comes on when the ignition switch is turned to the “ON” position and goes off a few seconds later.

► Any of the following indicates that the ABS is not functioning and only Caution

► Any of the following indicates that the ABS is not functioning and only the standard brake system is working. (The standard brake system is functioning normally.) If this happens, we recommend you to have your vehicle inspected as soon as possible.
• When the ignition switch is in the “ON” position, the warning lamp does not come on or it remains on and does not go off
• The warning lamp comes on while driving
• The warning display appears while driving

    See also:

    Operation of the Dead Lock System
    In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the remote controller. (Refer to “Dead Lock System”.) ...

    Buying a Mitsubishi Carisma
    This is a bit of a difficult one, as there's not too much to worry about, which is excellent news for you. So, provided you're buying a car with full service history, you shouldn't be in for any n ...

    To remove the spare tyre
    1. Lift up the board. 2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise. Note ► Put the spare wheel under the vehicle body near the jack. This make ...