Obstacle detection areasObstacle detection areas  - Reversing sensor system - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The detection areas of the corner and back sensors are limited to those shown in the illustration. Moreover, the sensors are unable to detect low or thin objects or objects near the rear bumper. Thus, make sure to check the surroundings as you operate the vehicle in a safe manner.

See also:

Leg area heating
Set the mode selection dial to the position shown in the illustration and set the air selection switch (A) to the outside position. Adjust the temperature by turning the temperature control dial ...

Vehicle care
In order to maintain the value of your vehicle, it is necessary to perform regular maintenance using the proper procedures. Always maintain your vehicle in compliance with any environmental pollut ...

To listen to the radio
1- PWR (On-off) switch 2- VOL (Volume control) knob 3- U/M/L (UKW/MW/LW selection) button 4- Audio adjust button 5- AUDIO button 6- TUNE/SEEK (Down-step/Down-seek) button 7- TUNE/SEEK (Up-step/U ...