Changing the detection areas
The detection areas can be changed as follows:
Vehicles with a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the “SONAR” switch approximately 3 seconds or more, and release it. The buzzer sounds twice to indicate that the detection area has been changed.
Vehicles without a towing bar
While the operation of the system is stopped at the “SONAR” switch, push the “SONAR” switch approximately 3 seconds or more, and release it. The buzzer sounds once to indicate that the detection area has been changed.
Note
► The detection area will not change if you keep the “SONAR” switch pushed for
10 seconds or more.
► After pushing the “SONAR” switch, reversing sensor system operation differs according
to the detection area setting.
• Setting when towing bar is not equipped When the gearshift lever or selector lever is moved to the “R” position, the reversing sensor system will operate even if corner sensor operation was stopped by pushing the “SONAR” switch.
• Setting when towing bar is equipped When reversing sensor system operation was stopped by pushing the “SONAR” switch, the reversing sensor system will not operate until the engine has been stopped even if the gearshift lever or selector lever is moved to the “R” position.
To resume reversing sensor system operation, push the “SONAR” switch or stop and restart the engine, and then move the gearshift lever or selector lever to the “R” position.
See also:
Weatherstripping
To prevent freezing of the weatherstripping on the doors, bonnet, etc., they
should be treated with silicone grease. ...
To operate
1. Stop the vehicle completely using the brake pedal.
2. Release the brake pedal and the hill start assist will maintain the braking force
applied while stopping for approximately 2 seconds.
3. De ...
Fuse load capacity
The fuse capacity and the name of the electrical systems protected by the fuses
are indicated on the inside of the coin box located at the driver’s leg area and
on the fuse box lid for fuses l ...