Customizing the air selection (Changing function settings)Customizing the air selection (Changing function settings)  - Control panel - Heater - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Functions can be changed as desired, as stated below.

► Enable automatic air control:
When the heater operates, the air selection switch will be automatically controlled.

► Disable automatic air control:
Even when the heater operates, the air selection switch will not be automatically controlled.

► Setting change method Hold down the air selection switch for about 10 seconds or more.

When the setting is changed, a sound is emitted and the indication lamp flashes.

• When the setting is changed from enable to disable 3 sounds are emitted and the indication lamp flashes 3 times.
• When the setting is changed from disable to enable 2 sounds are emitted and the indication lamp flashes 3 times.

► The factory setting is “Enable automatic air control.” Note

► The factory setting is “Enable automatic air control.”
► When the mode selection dial is turned to windows the ventilator automatically switches to outside air even if “Disable automatic, in order to prevent misting of the windows the ventilator automatically switches to outside air even if “Disable automatic air control” is set.

    See also:

    Indicator lamps
    Turn-signal indicator lamps/Hazard warning indicator lamps These indicator lamps blink on and off when a turn-signal lamp is operating. NOTE: ● If the blinking is too fast, the cause may be ...

    Starting the engine
    [For vehicles equipped with the keyless operation system]. For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system: Starting”, ...

    3-point type seat belt with 2 buckles
    3-point type seat belt with 2 buckles is fitted in the rear centre seating position. To fasten 1. Pull the seat belt out slowly and pass it through the seat belt guide (A). NOTE • When the se ...