Digital clock
Automatic mode and manual mode are available for digital clock adjustment.
Select the automatic mode or the manual mode by performing the following operations: 1. Press the PWR switch (A) to turn ON the audio system.
2. Enter the function setup mode by pressing the TUNE switch (B) for 2 sec. or longer.
3. Press the TUNE switch (B) repeatedly to select the CT (Clock Time) mode.
The order is: AF → CT → REG → TP-S → PI-S → Language of PTY display → SCV → PHONE → Function setup mode OFF. (Refer to “Function setup mode” on pages 5-25, 5-39.)
Note
► Although “PHONE” appears on the display, the PHONE function is inoperative.
4. Turn the TUNE switch (B) left and right and select either ON or OFF.
CT ON- Automatic mode
CT OFF- Manual mode
Note
► After selecting a mode, you can leave the function setup mode by taking either
of the following steps:
• Press the TUNE switch (B) for at least 2 seconds.
• Make no entry for 10 seconds.
See also:
Wheel condition
1- Location of tread wear indicator 2- Tread wear indicator
Check the tyres for cuts, cracks and other damage. Replace the tyres if there
are deep cuts or cracks. Also check each tyre for pieces ...
Momentary fuel consumption display
While driving, this displays the momentary fuel consumption, using a bar graph.
When the momentary fuel consumption surpasses the average fuel consumption, the
momentary fuel consumption is displ ...
Key lock-in prevention system
When the ignition switch is in the “LOCK” (PUSH OFF) position, if you close all
the doors and the rear hatch with the keyless operation key left in the vehicle
and you try to lock the doors ...