Types of connectable devices and supported file specificationsTypes of connectable devices and supported file specifications  - USB input terminal - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Device types

Devices of the following types can be connected.

: “iPod touch,” “iPod classic,” “iPod” and “iPod nano” are registered trademarks

: “iPod touch,” “iPod classic,” “iPod” and “iPod nano” are registered trademarks of Apple Inc. in the United States and other countries.

► Depending on the type of the USB memory device or other device connected, the Note

► Depending on the type of the USB memory device or other device connected, the connected device may not function properly or the available functions may be limited.
► Use the iPod whose firmware has been updated to the latest version.
► You can charge your iPod by connecting it to the USB input terminal when the ignition switch is in the “ON” or “ACC” position.
► Do not keep your USB memory device or iPod in your vehicle.
► It is recommended that you back up files in case of data damage.
► Do not connect to the USB input terminal any device (hard disk, card reader, memory reader, etc.) other than the connectable devices specified in the previous section.
The device and/or data may be damaged. If any of these devices was connected by mistake, remove it after turning the ignition switch to the “LOCK” position.

File specifications

You can play music files of the following specifications that are saved in a USB memory device or other device supporting mass storage class.

Sun visors

    See also:

    Wiper blades
    If the blades are frozen to the window glass, do not operate the wipers until the ice has melted and the blades are freed, otherwise the wiper motor may be damaged. Wiper blade rubber replacement ...

    Electric window control
    The electric windows can only be operated with the ignition switch in the “ON” position. WARNING: ● Before operating the electric window control, make sure that nothing is capable of b ...

    Side turn-signal lamps
    Insert a straight blade (or minus) screwdriver at the edge of the lens, remove the socket assembly and bulb together by turning it anticlockwise, and then remove the bulb by pulling out. NOTE ...