Accessory socket
The accessory socket can be used while the ignition switch is in the “ON” or “ACC” position.
Caution
► Be aware that using electronic equipment with the engine off may run the
battery down.
► When you connect an electrical device, make sure it is rated at 12 V and its electrical
capacity does not exceed 120 W.
When using some sockets at the same time, make sure the total power consumption
of the electrical accessories does not exceed 120 W at 12 V.
► When the accessory socket is not in use, be sure to close the cap or plug, because
the socket might become clogged by foreign material and be shortcircuited.
► When using two accessory sockets or the accessory socket and cigarette lighter
simultaneously, make sure the total power consumption of these does not exceed 120
W at 12 V.
Note
► The two accessory sockets can be used simultaneously.
Type 1, Type 2
Pull out the plug to uncover the socket. Use it to plug in an electrical device.
Type 3
To use a “plug-in” type accessory, open the cover, then insert the plug in the socket.
See also:
CD control panel and display
1- AM/FM button
2- CD (CD mode changeover) button
3- PWR (On-Off) switch
4- LOAD indicator
5- LOAD button
6- PAGE (Title scroll) button
7- DISP (Display) button
8- RPT (Repeat) button
9- R ...
Odometer/Tripmeter
Each time you lightly press the multi-information meter switch, the display screen
switches.
Odometer/Tripmeter → Odometer/Tripmeter
→ Service reminder → Redisplay of a
warnin ...
Cooling (Vehicles with air conditioning)
Set the mode selection dial to the “”
position.
Set the air selection switch (A) to the outside position and push the air conditioning
switch (B).
Adjust the temperature by turning the tem ...