Rear room lamp
The room lamp can be turned on by sliding the room lamp switch.
1 (ON) - The room lamp goes on.
2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes off about 15 seconds after the door or rear hatch is closed.
However, the lamp goes off immediately in the following cases: ► The ignition switch is turned to the “ON” position.
► All the doors and the rear hatch are locked using the central door lock function.
► If the vehicle is equipped with the keyless entry system, when the remote control switch of the keyless entry system is used to lock the vehicle.
► If the vehicle is equipped with the keyless operation system, when the remote control switch of the keyless operation system or the keyless operation function is used to lock the vehicle.
Note
► When the key was used to start the engine, if the key is removed while the doors and rear hatch are closed, the lamp is illuminated and after about 15 seconds it goes off.
► When the keyless operation function was used to start the engine, if the ignition switch is turned to the “LOCK” position while the doors and rear hatch are closed, the lamp illuminates and after about 15 seconds it goes off.
► The time until the lamp goes off can be adjusted.
For details, please consult a MITSUBISHI MOTORS Authorized Service Point.
If the vehicle is equipped with the MITSUBISHI Multi-Communication System (MMCS), adjustment can be made using screen operations. Refer to the separate owner’s manual for details.
3 (OFF) - The lamp goes off.
See also:
To listen to the radio
1. Press the PWR switch or the AM/FM button to turn ON the radio.
Press the PWR switch again to turn OFF the radio.
2. Press the AM/FM button to select the desired band.
3. Turn the TUNE switch, or ...
Setting of door and rear hatch unlock function (vehicles equipped with the central
door lock switch)
The door and rear hatch unlock function can be set to the following two conditions.
Each time the door and rear hatch unlock function is set, a chime will sound
to tell you the condition of the doo ...
Display brightness adjustment / Display unit selection
Display brightness adjustment
1. Press the “H” button while pressing the button (A) to activate the display
brightness selection function.
2. Adjust the brightness by moving the cursor with ...