Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system
or keyless operation system)
If any of the interior lamps are left switched on with the ignition switch in any position other than “ON” or “ACC”, it goes off automatically after approximately 30 minutes.
The lamp goes on again if the ignition switch is turned to the “ON” or “ACC” position, any door or the rear hatch is opened and closed, or the keyless entry remote control or the keyless operation system is operated.
Note
► The interior lamps auto-cutout function can be deactivated. The time until the lamps automatically go off can be adjusted. For details, please consult a MITSUBISHI MOTORS Authorized Service Point.
If the vehicle is equipped with the MITSUBISHI Multi-Communication System (MMCS), adjustment can be made using screen operations. Refer to the separate owner’s manual for details.
See also:
Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted. Move the seat belt anchor up or
down with the lock knob (A) depressed.
CAUTION
When adjusting the seat belt anchor, set it at a position that is suff ...
Cautions on handling of 4-wheeldrive vehicles
Tyres and wheels
Since the driving torque can be applied to the 4 wheels, the driving performance
of the vehicle when operating in 4-wheel drive is greatly affected by the condition
of the tyres. ...
Moving the gearshift lever to the “R” (Reverse) position
Vehicles equipped with 5M/T
To shift into the “R” (Reverse) position from 5th gear, move the gearshift lever
to the “N” (Neutral) position, and then move it to the “R” (Reverse) positio ...