Vehicle equipped with steel wheelsVehicle equipped with steel wheels  - How to change a tyre - For emergencies - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Tighten the wheel nuts (tapered nuts) until the tapered parts of the wheel nuts make light contact with the seats of the wheel holes and the wheel is not loose.

With a spare wheel, tighten the wheel nuts in the same way.

Vehicle equipped with aluminium wheels

Vehicle equipped with aluminium wheels

Tighten the wheel nuts (flange nuts) until the flanges of the wheel nuts touch the wheel and the wheel is not loose.

Note

► Flange nuts can be temporarily used on the steel spare wheel as shown in the Note

► Flange nuts can be temporarily used on the steel spare wheel as shown in the illustration, but return to the original wheel and tyre as soon as possible.

► If all 4 aluminium wheels are changed to steel wheels, e.g. when fitting winter

► If all 4 aluminium wheels are changed to steel wheels, e.g. when fitting winter tyres, use tapered nuts.

► Never apply oil to either the wheel bolts or the nuts, or they will tighten Caution

► Never apply oil to either the wheel bolts or the nuts, or they will tighten too much.

8. Lower the vehicle slowly by rotating the wheel nut wrench anticlockwise until the tyre touches the ground.

9. Tighten the nuts in the order shown in the illustration until each nut has

9. Tighten the nuts in the order shown in the illustration until each nut has been tightened to the torque listed here.

Tightening torque 88 to 108 Nm (Achieved by applying a force of 350 to 420 N at the end of the wheel nut wrench supplied with the vehicle.)

Caution

► Never use your foot or a pipe extension for extra force in the wheel nut Caution

► Never use your foot or a pipe extension for extra force in the wheel nut wrench.

If you do so, you will tighten the nut too much.

10. Lower the jack all the way and remove it.
11. Check your tyre inflation pressure at the next gasstation. The correct pressures are shown on the door label. See the illustration.

Caution

► The tyre pressure should be periodically checked and maintained at the specified Caution

► The tyre pressure should be periodically checked and maintained at the specified pressure while the tyre is stowed.
► The compact spare tyre is to be used only temporarily when the standard tyre is damaged. Repair the damaged tyre as soon as possible and use it to replace the compact spare tyre.
► After changing the tyre and driving the vehicle about 1.000 km (620 miles), retighten the wheel nuts to make sure that they have not come loose.
► If the steering wheel vibrates when driving after changing the tyre, we recommend you to have the tyres checked for balance.
► Do not mix one type of tyre with another or use a different size from the one listed.

This would cause early wear and poor handling.

    See also:

    Service reminder
    Displays the approximate time until the next periodic inspection that MITSUBISHI MOTORS recommends. “---” is displayed when the inspection time has arrived. Note ► Depending on the veh ...

    Front passenger seat belt warning lamp
    The front passenger seat belt warning lamp is located on the instrument panel. The lamp comes on when a person sits on the front passenger seat but does not fasten the seat belt. It goes off when ...

    Electrical system
    ...