Diesel-powered vehiclesDiesel-powered vehicles - Selection of engine oil - Engine oil - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► Select engine oil of the proper SAE viscosity number according to the atmospheric

► Select engine oil of the proper SAE viscosity number according to the atmospheric temperature.

► Use engine oil conforming to the following classification: • ACEA classification:
“For service C1, C2, C3 or C4”
• JASO classification:
“For service DL-1”
If those classifications are not available, contact a MITSUBISHI MOTORS Authorized Service Point.

► Use of additives is not recommended since they may reduce the effectiveness Note

► Use of additives is not recommended since they may reduce the effectiveness of additives already included in the engine oil. It may result in failure of the mechanical assembly.

    See also:

    Setting the system
    1. Turn the ignition switch to the “LOCK” position. Also, if a key was used to start the engine, remove the key from the ignition switch. 2. Get out of the vehicle. Close all doors and rear ha ...

    To change a tyre
    1. If a wheel cover is installed, first remove the cover. (Refer to “Wheel covers”.) Then loosen the wheel nuts a quarter turn with the wheel nut wrench. Do not remove the wheel nuts yet. 2 ...

    Hill start assist (vehicles with Twin Clutch SST)
    The hill start assist makes it easy to start off on a steep uphill slope by preventing the vehicle from moving backwards. It keeps the braking force for about 2 seconds when you move your foot fro ...