To lock
Press the LOCK switch (1). All the doors and the tailgate will be locked. The turn-signal lamps will blink once when the doors and the tailgate are locked.
NOTE
• With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two times in succession causes the Dead Lock System to be set. (Refer to “Setting the system”.)
See also:
Tips for starting
(1) Do not operate the starter motor continuously for anything longer than 10
seconds; doing so could run down the battery. If the engine does not start, turn
the ignition switch back to “LOCK ...
Engine compartment fuse location table
1: Except for petrol-powered vehicles equipped with turbocharger
2: Petrol-powered vehicles with turbocharger
3: Fusible link
1: Except for petrol-powered vehicles equipped with turbochar ...
Accessory socket
The accessory socket can be used while the ignition switch is in the “ON” or
“ACC” position.
Caution
► Be aware that using electronic equipment with the engine off may run the
bat ...