Central door locksCentral door locks  - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

• Each of the doors can be locked or unlocked independently by using the inside NOTE

• Each of the doors can be locked or unlocked independently by using the inside lock knob.
• When locking or unlocking with the key on the driver’s door, only the driver’s door will lock or unlock.
• Repeated continuous operation between lock and unlock could activate the central door locking systems built-in protection circuit and prevent the system from operating.

If this occurs, wait approximately 1 minute before operating the central door lock switch.

• When the driver’s door is open, the central door lock switch cannot be used to lock it.

To lock and unlock the doors and tailgate

Using the central door lock switch

Using the central door lock switch on the driver’s door locks or unlocks all doors and the tailgate.

1- Lock

1- Lock
2- Unlock

To unlock the doors and tailgate

You can select the functions to unlock the doors and tailgate either using the ignition switch or the engine switch, or using the selector lever position (CVT).

These functions are not activated when the vehicle is shipped from the factory. To activate or deactivate these functions, please contact a MITSUBISHI MOTORS Authorized Service Point.

• When the electric window lock switch is in the lock mode, the door and tailgate NOTE

• When the electric window lock switch is in the lock mode, the door and tailgate unlocking function will be deactivated.

Refer to “Electric window control: Lock switch”.

Consult a MITSUBISHI MOTORS Authorized Service Point.

Using the ignition switch or the engine switch

All doors and the tailgate will unlock whenever the ignition switch is turned to the “LOCK” position or the operation mode is put in OFF.

Using the selector lever position (CVT)

All doors and the tailgate will unlock whenever the selector lever is moved to the “P” (PARK) position with the ignition switch in the “ON” position or the operation mode in ON.

NOTE

• On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen NOTE

• On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.

Refer to the separate owner’s manual for details.

    See also:

    Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
    1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle. : Front of the vehicle 2 ...

    Caution for installing the child restraint on vehicles with a front passenger airbag
    The label shown here is attached on vehicles with a front passenger airbag. Warning ► Extreme Hazard! Do not use a rearward facing child restraint on a seat protected by an airbag in fro ...

    Combination headlamps, dipper and turn signal switch
    Headlamps Rotate the switch to turn on the lamps. –All lamps off –Position, tail, licence–plate, and instrument panel lamps on –Headlamps on and other lamps remain on Lamp monitor ...