To recline the seatbackTo recline the seatback  - Front seat - Seat and seat belts - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

Manual type

In order to recline the seatback, lean forward slightly, pull the seatback lock lever up, and then lean backward to the desired position and release the lever.

The seatback will lock in that position.

CAUTION

• The reclining mechanism of the seatback is spring loaded, causing it to CAUTION

• The reclining mechanism of the seatback is spring loaded, causing it to return to the vertical position when the lock lever is operated. When using the lever, sit close to the seatback or hold it with your hand to control its return motion.

Power type

Adjust the seatback angle by operating the switch as indicated by the arrows.

1- To move to forward direction

1- To move to forward direction
2- To recline rearward

• To prevent the battery from discharging, use the power seat while the engine NOTE

• To prevent the battery from discharging, use the power seat while the engine is on.

    See also:

    Volume and tone control panel
    1- PWR (On-Off) switch 2- VOL (Volume control) knob 3- Display 4- SOUND (Sound control) switch ...

    To store the flat tyre or spare wheel
    1. Lift up the board. 2. To store the flat tyre or spare wheel, fit the installation clamp (A) by turning it clockwise. Note ► On vehicles equipped with a compact spare wheel, the clamp ...

    Operation of the Dead Lock System
    In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the remote controller. (Refer to “Dead Lock System”.) ...