Headlamp flasherHeadlamp flasher  - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

The high-beams flash when the lever is pulled slightly (2), and will go off when it is released.

When the high-beam is on, the high-beam indication lamp in the instrument cluster will illuminate.

• The high-beams can also flash when the lamp switch is OFF. NOTE

• The high-beams can also flash when the lamp switch is OFF.

• If you turn the lamps off with the headlamps set to high-beam, the headlamps are automatically returned to their low-beam setting when the lamp switch is next turned to the Welcome light position.

    See also:

    To change a tyre
    1. On vehicles equipped with wheel covers, first remove the covers (refer to “Wheel covers”). Then loosen the wheel nuts a quarter turn with the wheel nut wrench. Do not remove the wheel nuts ...

    Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system or keyless operation system)
    If any of the interior lamps are left switched on with the ignition switch in any position other than “ON” or “ACC”, it goes off automatically after approximately 30 minutes. The lamp goe ...

    Safe driving techniques
    Driving safety and protection against injury cannot be fully ensured. However, we recommend that you pay extra attention to the following: (1) Before starting the vehicle, make sure that you and yo ...