To remove the spare wheelTo remove the spare wheel - How to change a tyre - For emergencies - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

1. Lift up the luggage floor board.
2. To remove the spare wheel, remove the installation clamp (A) by turning it anticlockwise.

NOTE

• Put the spare wheel under the vehicle body near the jack. NOTE

• Put the spare wheel under the vehicle body near the jack.

This makes it safer if the jack slips out of position.

To change a tyre

    See also:

    Changing the detection areas
    The detection areas can be changed as follows: Vehicles with a towing bar While the operation of the system is stopped at the “SONAR” switch, push the “SONAR” switch approximately 3 second ...

    Operation of the Dead Lock System
    In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the remote controller. (Refer to “Dead Lock System”.) ...

    To install
    Align the tyre valve with the valve opening provided on the wheel cover. Then tap around the outer edge of the wheel cover with your hand to secure it in place. NOTE Full wheel covers have a sy ...