To store the flat tyre or spare wheelTo store the flat tyre or spare wheel  - How to change a tyre - For emergencies - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

1. Lift up the luggage floor board.
2. To store the flat tyre or spare wheel, fit the installation clamp (A) by turning it clockwise.

NOTE

• On vehicles with a T155/90D16 or T125/90D16 size spare wheel, the clamp cannot NOTE

• On vehicles with a T155/90D16 or T125/90D16 size spare wheel, the clamp cannot be used for a normal size tyre.

3. Have your damaged tyre repaired as soon as possible.

To store the tools and jack

Reverse the removing procedure when storing the jack, jack bar and wheel nut wrench.

Refer to “Tools, jack and tyre repair kit”.

    See also:

    Auto Stop & Go (AS&G) system
    This paragraph summarizes the major items of the Auto Stop & Go (AS&G) system such as the characteristics, operating procedures, etc. For details, refer to “Auto Stop & Go (AS&G) ...

    Door ajar warning display screen (when the ignition switch is “ON”)
    If any of the doors or the rear hatch is not completely closed, this displays the open door or rear hatch. If the vehicle speed exceeds approximately 8 km/h (5 mph) while a door is ajar, a buzz ...

    Introduction of outside air
    To introduce air into the vehicle during hot weather, set the air selection switch (A) to the outside position and set the temperature control dial to the position shown in the illustration. Be ...