Tyre inflation pressure
Check the tyre inflation pressure of all the tyres while they are cold: if insufficient
or excessive, adjust to the specified value.
After the tyre inflation pressure
has been adjusted, check the tyres for damage and air leaks. Be sure to put rubber
caps on the valves.
See also:
Ignition switch turn-off reminder system
When the ignition switch is in any position other than the “LOCK” (PUSH OFF)
position, if you close all the doors and the rear hatch then try to lock the doors
and rear hatch by pressing the ...
Exterior and interior lamp operation
Operate the combination lamp switch to check that all lamps are functioning properly.
If the lamps do not illuminate, the probable cause is a blown fuse or defective
lamp bulb. Check the fuses fir ...
To remove the spare tyre
1. Lift up the board.
2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise.
Note
► Put the spare wheel under the vehicle body near the jack. This make ...