Exterior and interior lamp operation
Operate the combination lamp switch to check that all lamps are functioning properly. If the lamps do not illuminate, the probable cause is a blown fuse or defective lamp bulb. Check the fuses first. If there is no blown fuse, check the lamp bulbs.
For information regarding the inspection and replacement of the fuses and the lamp bulbs, refer to the section entitled “For emergencies”.
If the fuses and bulbs are all OK, take the vehicle to an authorized MITSUBISHI dealer for inspection and repair.
See also:
Bluetooth® 2.0 interface
The Bluetooth® 2.0 interface allows for making/receiving hands-free calls in
the vehicle using a Bluetooth ® compatible cellular phone based on the wireless
communication technology commonly kno ...
Twin Clutch SST control mode display
When the ignition switch is turned to the “ON” position, the currently selected
control mode is displayed on the multi-information display.
...
Tether anchorage locations
There are 2 child restraint anchorage points located on the back of the seatbacks.
These are for fastening the child restraint tether straps to the 2 rear seat seating
positions.
Warning
` ...
